Code Corporation СК1000 Manual do Utilizador descarregar pdf (Página 5)

C005905_05_CR1000_User_Manual

3.0 - Aaching Cable and Powering On/O the Reader

1.0 - Unpacking

Remove the CR1000 from its packing and inspect it for damage. If the reader was damaged during shipping, please call Code at

(801) 495-2200.

Depending on the kit ordered, a USB or RS232 Anity® cable has been included with your reader.

USB Anity® Cable

RS232 Anity® Cable

w/ Power Supply

For USB Cable: plug the USB end of the Anity® cable into a USB port on the host device. Aer several seconds, the reader will beep

twice, the LED will turn o and the CR1000 is ready for use.

For RS232 Cable: plug the power supply into the AC outlet, plug the power supply cord into the barrel jack of the cable, and connect

the RS232 connector to the appropriate serial port on the host device. Aer several seconds, the reader will beep twice, the LED will

turn o and the CR1000 is ready for use.

To aach a cable, plug the RJ-50 end of the Anity® cable into boom of the reader (Figure 1). Firmly push the connector into the

reader, unl a snap can be heard to indicate the cable is properly aached. To detach a cable, press a paper clip into the hole on the

back of the CR1000 (Figure 2), and gently pull the cable from the reader.

2.0 - Aaching and Detaching a Cable

Figure 1 Figure 2

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Code Corporation СК1000 Manual do Utilizador Página 5